7. Handling and storage
In a fully ventilated place, especially in confined areas.
Wear personal protective equipment.
Avoid eyes and skin.
On proper labeled container, the container tightly sealed in a cool dry and ventilated good place.
Push open the open fire, hot surface and ignition source. Forced to open direct sunlight.
____________________________________________________________________________________
8. Exposure control/personal protection
Some technological measures to reduce the exposure.
Ensure adequate ventilation, especially in a closed place.
We don't know any national standard exposure limit.
To filter the organic vapor respirator.
Seal of gloves, suitable materials: nitrile rubber, butyl rubber. Carefully read the instruction manual supplied with manufacturer, special attention on permeability and through time. Also want to focus on the gloves to use local special conditions, such as the risk of broken insulation, wear and contact time.
Protective clothing/chemical skirt and boots.
In use before the transfer and cleaning the contaminated clothes and gloves, including inside.
Avoid contact with skin, eyes and clothing. In the process of using do not eat, drink or smoke,
Before the rest, immediately wash your hands after handling.
Avoid products into the drain, don't allow this matter pollution surface water system.
____________________________________________________________________________________
9. The physical and chemical properties
An overview of the
Liquid appearance: colorless transparent/trace the smell
Important health safety and environmental impact information
PH data is not applicable to
Boiling point: 200 ℃ >
Flash: 172.8 ℃
The explosion limit: no applicable data
Vapor pressure: 2 mm Hg (166 ℃)
Steam density: no applicable data
Evaporation than: < 1 (Mr = 1)
Relative density: 1.143
Bulk density: 9.57 LBS/gal
Water solubility: insoluble
Other information
Melting point: - 4 ℃
____________________________________________________________________________________
10.Stability and reactivity
The stability of
In the general case.
# aggregation danger
The possible dangers of polymerization reaction.
The conditions of the need to avoid
In the wet may break down.
To avoid thermal decomposition, to avoid overheating.
Material forced open
Can cause aggregation of substances: water, alkali.
# dangerous decomposition
Propylene glycol, oxidation of carbon
# other information
Monomer and IPP: keep temperature below 5 ℃.
____________________________________________________________________________________
11. The toxicity of information
Acute toxicity
The rabbit percutaneous LD50 > 3038 mg/kg. Mice LD50 = 515 mg/kg
Mouse one hour inhaling LC50 > 0.73 mg/l
# local influence
Swallowed, contact with the skin, breathing in harmful, can irritate to eyes, respiratory system and skin.
Breathing high concentrations of steam the following effects: can irritate the respiratory system. This material intake can result in upper gastrointestinal tract and respiratory tract burn. The product ingredients can be absorbed by the body through the skin.
Chronic toxicity
Long time contact with skin may cause skin irritation.
Long or repeated contact with skin may result in poor resistance people produce allergic reaction.
# increase light sensitivity
In experimental animals have not found can enhance sensitivity.
# special effects
Carcinogenic effects: in the NTP, OSHA, IARC not listed in the magazine.
Mutations affecting: not found in bacteria and mammalian cell test for mutations.
For some animal experiment showed that the product may be of embryo toxicity. Based on these results, completes the protection measures against the material toxicity can provide protection against potential toxicity and teratogenic toxicity.
____________________________________________________________________________________
12. The biological information
mobility
Do not dissolve.
Keep sex/degradability
Ecological toxicity
The sun LC50/96 h/big fish = 0.57 mg/l (high toxic); LC50/96 h/sheepshead = 0.707 PPM (high toxic)
EC50 > 10 mg/l / 96 h/algae (medium toxicity)
____________________________________________________________________________________
13. Disposal of considering
# the waste residue or not use the product
According to local regulations.
The packing of the pollution
Empty containers can be recycled or recovery or waste disposal.
# in addition
According to the European waste catalogue, waste code is not according to the material properties, but application features.
The waste code is according to specify the purpose of the product by the user.
____________________________________________________________________________________
14. The transportation information
According to the rules were not classified as dangerous goods transport.
____________________________________________________________________________________
15. Adjust the information
# product classification according to 67/548 / EEC instructions VI accessories.
Symbol Xn harmful - N - have harm to the environment
The R20 # R - phrase (s) / 21/22 - harmful swallowed, contact with the skin, or inhaled.
R36/37/38 - can irritate to eyes, respiratory system and skin.
R50/53 - high toxicity to aquatic organisms, may cause long-term effects to water environment.
S - phrase (S) S24/25 to avoid contact with eyes and skin.
S36 wear suitable protective clothing.
S60 this material and/or its packaging must be as a hazardous waste treatment.
____________________________________________________________________________________